This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. this device must accept any interference received, including interference that may cause undesired operation.this device may not cause harmful interference, and.Operation is subject to the following two conditions: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. Information to the User (FCC Part 15.105) Register your product warranty online at COMPLIANCE Please refer to warranty‑conditions for full warranty terms and conditions. To maintain a waterproof* /splash proof seal, ensure that the battery cap O-ring is periodically lubricated with silicone grease.Īlways check that the battery cap O-ring and screw threads are clear of dust, sand, and grit. One long beep followed by two short beeps will indicate when Factory Reset is complete. After two long beeps, continue to hold for 5 seconds. Factory Resetįrom off, press and hold the Power button (5). If + (6) or – (7) are not pressed at all when turning on the pinpointer, it will default to the last-use audio mode. To turn audio tones OFF, hold down – (7) when turning on the pinpointer. To turn audio tones ON (default), hold down + (6) when turning on the pinpointer. To disable Ferrous Tone ID, press and hold – (7) for 3 seconds, until the unit emits one long beep. Interrupted chirping tones upon detection indicate a ferrous target.įerrous Tone ID is effective when the probe is 10–15 mm (approx. When the pinpointer is close to the target: To enable Ferrous Tone ID, hold the pinpointer away from metal objects, then press and hold + (6) for 3 seconds. When minimum sensitivity is exceeded (level 1), there will be a long beep. When maximum sensitivity is exceeded (level 5), there will be a long beep. When the battery level is critically low, the pinpointer will automatically power off. Low Battery is indicated by a flashing LED* (3). If the pinpointer is inactive for another 5 minutes, it will automatically power off. This will repeat every 10 seconds unless a detection occurs. When the pinpointer is switched on but has been inactive for approximately 3 minutes, a long alert beep will emit. Three short beeps will emit and the pinpointer will power off. When the detected object is very close to the probe, the beep becomes a continuous tone. When a detection occurs, the vibration* will intensify, and the beeps will emit increasingly closer together. When auto-calibration is complete, a short beep indicates that the pinpointer is ready to use. The unit will beep twice and the LED (3)* will illuminate. This Minelab metal detector includes a holster and lanyard.With probe at least 300mm/1' away from metal objects, press the Power button (5). A bright yellow handle means if you set it down, it'll be hard to forget, but if you do forget it, the Pro-Find 35 Pinpointer Handheld Metal Detector boasts a convenient lost alarm that sounds after a set time of inactivity. A built-in LED flashlight lets you hunt those dark crevices. Audible and vibration feedback increase the closer you get to the target. Adjustable sensitivity lets you select between 5 levels to find the best combination of depth and noise. Detector Interference Free (DIF) technology disengages the pinpointer coil's magnetic field so it won't interfere with your other detectors. A waterproof housing means it can be used as much as 10' under water, while Ferrous Tone ID provides 2 responses so you can easily tell junk from treasure. Whether you need to search in tight spaces a regular detector can't reach or you just need precision help, the Minelab® Pro-Find 35 Pinpointer Handheld Metal Detector is an essential tool for your treasure-hunting adventures.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |